ZyXEL Communications NWA1000 Series - Page 22

Chapter 3 Hardware
NWA1000 Series User’s Guide
22
Figure 7 NWA1123-AC HD LED
The following are the LED descriptions for your NWA1000 Series.
Table 4 NWA1123-AC HD LED
COLOR STATUS DESCRIPTION
Amber Blinks amber for 1 second
and green for 1 second
alternatively.
The NWA1000 Series is booting up.
Green
Green Slow Blinking (On for 1
second, Off for 1 second)
The wireless module of the NWA1000 Series is disabled or fails,
the NWA1000 Series is using default wireless settings.
Green Steady On The NWA1000 Series is ready for use, the NWA1000 Series’s
wireless interface is activated, and/or wireless clients are
connected to the NWA1000 Series when it receives power
using IEEE 802.3at PoE plus (full power mode).
Amber Steady On The NWA1000 Series is ready for use, the NWA1000 Series’s
wireless interface is activated, and/or wireless clients are
connected to the NWA1000 Series when it receives power
using 802.3af PoE (limited power mode).
Bright Blue Steady On The NWA1000 Series’s wireless interface is activated, but there
are no wireless clients connected when it receives power
using IEEE 802.3at PoE plus (full power mode).
White Steady On The NWA1000 Series’s wireless interface is activated, but there
are no wireless clients connected when it receives power
using 802.3af PoE (limited power mode).
Blue Slow Blinking (Blink for 1
time, Off for 1 second)
The NWA1000 Series is performing a Channel Availability
Check (CAC) with Dynamic Frequency Selection (DFS) to
monitor a channel for radar signals.
Red On The NWA1000 Series failed to boot up or is experience system
failure.
Fast Blinking (On for 50
milliseconds, Off for 50
milliseconds)
The NWA1000 Series is undergoing firmware upgrade.
Slow Blinking (Blink for 3
times, Off for 3 seconds)
The Uplink port of the NWA1000 Series is disconnected.