ZyXEL Communications NWA1000 Series - Ftp

Chapter 15 System
NWA1000 Series User’s Guide
153
The following table describes the labels in this screen.
15.7 FTP
You can upload and download the NWA1000 Series’s firmware and configuration files using FTP. To use
this feature, your computer must have an FTP client. See Chapter 17 on page 170 for more information
about firmware and configuration files.
To change your NWA1000 Series’s FTP settings, click Configuration > System > FTP tab. The screen
appears as shown. Use this screen to specify FTP settings.
Figure 99 Configuration > System > FTP
The following table describes the labels in this screen.
Table 67 Configuration > System > TELNET
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that matches the IP
address(es) in the Service Control table to access the NWA1000 Series CLI using this service.
Server Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Apply Click Apply to save your changes back to the NWA1000 Series.
Reset Click Reset to return the screen to its last-saved settings.
Table 68 Configuration > System > FTP
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that matches the IP
address(es) in the Service Control table to access the NWA1000 Series using this service.
TLS required Select the check box to use FTP over TLS (Transport Layer Security) to encrypt communication.
This implements TLS as a security mechanism to secure FTP clients and/or servers.
Server Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Server Certificate Select the certificate whose corresponding private key is to be used to identify the NWA1000
Series for FTP connections. You must have certificates already configured in the My Certificates
screen.
Apply Click Apply to save your changes back to the NWA1000 Series.
Reset Click Reset to return the screen to its last-saved settings.