ZyXEL Communications NWA1000 Series - HTTPS Example

Chapter 15 System
NWA1000 Series User’s Guide
142
Figure 88 Configuration > System > WWW > Service Control
The following table describes the labels in this screen.
15.4.5 HTTPS Example
If you haven’t changed the default HTTPS port on the NWA1000 Series, then in your browser enter
“https://NWA1000 Series IP Address/” as the web site address where “NWA1000 Series IP Address” is the
IP address or domain name of the NWA1000 Series you wish to access.
Table 65 Configuration > System > WWW > Service Control
LABEL DESCRIPTION
HTTPS
Enable Select the check box to allow or disallow the computer with the IP address that matches
the IP address(es) in the Service Control table to access the NWA1000 Series Web
Configurator using secure HTTPs connections.
Server Port The HTTPS server listens on port 443 by default. If you change the HTTPS server port to a
different number on the NWA1000 Series, for example 8443, then you must notify people
who need to access the NWA1000 Series Web Configurator to use “https://NWA1000
Series IP Address:8443” as the URL.
Authenticate Client
Certificates
Select Authenticate Client Certificates (optional) to require the SSL client to authenticate
itself to the NWA1000 Series by sending the NWA1000 Series a certificate. To do that the
SSL client must have a CA-signed certificate from a CA that has been imported as a
trusted CA on the NWA1000 Series.
Server Certificate Select a certificate the HTTPS server (the NWA1000 Series) uses to authenticate itself to the
HTTPS client. You must have certificates already configured in the My Certificates screen.
Redirect HTTP to HTTPS To allow only secure Web Configurator access, select this to redirect all HTTP connection
requests to the HTTPS server.
HTTP
Enable Select the check box to allow or disallow the computer with the IP address that matches
the IP address(es) in the Service Control table to access the NWA1000 Series Web
Configurator using HTTP connections.
Server Port You may change the server port number for a service if needed, however you must use
the same port number in order to use that service to access the NWA1000 Series.
Apply Click Apply to save your changes back to the NWA1000 Series.
Reset Click Reset to return the screen to its last-saved settings.