Chapter 19 LEDs
NWA1000 Series User’s Guide
184
Figure 114 Maintenance > LEDs > Suppression
The following table describes fields in the above screen.
19.3 Locator Screen
The Locator feature identifies the location of your NWA1000 Series among several devices in the
network. You can run this feature and set a timer in this screen.
To run the locator feature, enter a number of minutes and click Turn On button to have the NWA1000
Series find its location. The Locator LED will start to blink for the number of minutes set in the Locator
screen. The default setting is 10 minutes. While the locator is running, the Turn On button will gray out
and return after it’s finished. If you make changes to the time default setting, it will be stored as the
default when the NWA1000 Series restarts.
Note: The Locator feature is not affected by the Suppression setting.
To access this screen, click Maintenance > LEDs > Locator.
Figure 115 Maintenance > LEDs > Locator
Table 82 Maintenance > LED > Suppression
LABEL DESCRIPTION
Suppression On If the Suppression On check box is checked, the LEDs of your NWA1000 Series will turn off
after it’s ready.
If the check box is unchecked, the LEDs will stay lit after the NWA1000 Series is ready.
Apply Click Apply to save your changes back to the NWA1000 Series.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
