Chapter 3 Hardware
NWA1000 Series User’s Guide
28
3.2.4 NWA1302-AC
By default, the LEDs automatically turn on when the NWA1302-AC is ready. If the LEDs are turned off by
the NCC, you can press the LED ON button for one second to turn on the LEDs again. The LEDs will blink
and turn off after two minutes.
Figure 12 MWA1302-AC LEDs
The following table describes the LEDs.
Table 9 NWA1302-AC LEDs
LED COLOR STATUS DESCRIPTION
PWR/SYS Red Slow Blinking (On for 1
sec, Off for 1 sec)
The LED blinks orange and green alternatively when the
NWA1000 Series is booting up.
Green On
Green On The NWA1000 Series is ready for use.
Slow Blinking (On for 1
sec, Off for 1 sec)
The wireless module of the NWA1000 Series is disabled or
failed.
Red On There is a system error and the NWA1000 Series cannot
boot up, or the NWA1000 Series suffered a system failure.
Fast Blinking (On for 50
ms, Off for 50 ms)
The NWA1000 Series is doing firmware upgrade.
Slow Blinking (Blink for 3
times, Off for 3 sec)
The Uplink port is disconnected.
Management Green On The NWA1000 Series is managed by the NCC.
Slow Blinking (On for 1
sec, Off for 1 sec)
The NWA1000 Series is connected to the NCC, but not
registered.
Amber Slow Blinking (On for 1
sec, Off for 1sec)
The NWA1000 Series is searching for (discovering) the
NCC.
UPLINK Amber/
Green
On Amber - The port is operating as a 10/100-Mbps
connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The NWA1000 Series is sending/receiving data through
the port.
Off The port is not connected.
To Next Page
Loading...
