NWA1000 Series User’s Guide
203
CHAPTER 27
Troubleshooting
27.1 Overview
This chapter offers some suggestions to solve problems you might encounter. The potential problems are
divided into the following categories.
• Power, Hardware Connections, and LED
• NWA1000 Series Access and Login
• Internet Access
• Wireless Connections
• Resetting the NWA1000 Series
27.2 Power, Hardware Connections, and LED
The NWA1000 Series does not turn on. The LED is not on.
1 Make sure you are using the power adaptor included with the NWA1000 Series or a PoE power injector/
switch.
2 Make sure the power adaptor or PoE power injector/switch is connected to the NWA1000 Series and
plugged in to an appropriate power source. Make sure the power source is turned on.
3 Disconnect and re-connect the power adaptor or PoE power injector/switch.
4 Inspect your cables for damage. Contact the vendor to replace any damaged cables.
5 If none of these steps work, you may have faulty hardware and should contact your NWA1000 Series
vendor.
The LED does not behave as expected.
1 Make sure you understand the normal behavior of the LED. See Section 3.1 on page 19 or Section 3.1 on
page 19.
2 Check the hardware connections. See the Quick Start Guide.
To Next Page
Loading...
