Chapter 6 Setup Wizard
NWA1000 Series User’s Guide
48
Figure 22 Wizard: Uplink
6.2.3 Step 3 Radio
Use this screen to configure the NWA1000 Series’s radio transmitter(s).
• Channel Width: Select the wireless channel bandwidth you want the NWA1000 Series to use. Because
not all devices support 40 MHz and/or 80 MHz channels, select 20/40/80MHz to allow the NWA1000
Series to adjust the channel bandwidth automatically.
• Channel Selection: Select Auto to have the NWA1000 Series automatically choose a radio channel
that has least interference. Otherwise, select Manual and specify a channel the NWA1000 Series will
use in the 2.4GHz or 5GHz wireless LAN. The options vary depending on the frequency band and the
country you are in.
• Maximum Output Power: Enter the maximum output power of the NWA1000 Series. If there is a high
density of APs in an area, decrease the output power of the NWA1000 Series to reduce interference
with other APs.
Note: Reducing the output power also reduces the NWA1000 Series’s effective broadcast
radius.
Click Prev to return to the previous screen. Click Next to proceed. Click Cancel to close the wizard
without saving.
To Next Page
Loading...
