NWA1000 Series User’s Guide
183
CHAPTER 19
LEDs
19.1 Overview
The LEDs of your NWA1000 Series can be controlled such that they stay lit (ON) or OFF after the NWA1000
Series is ready. There are two features that control the LEDs of your NWA1000 Series - Locator and
Suppression.
19.1.1 What You Can Do in this Chapter
• The Suppression screen (Section 19.2 on page 183)) allows you to set how you want the LEDs to
behave after the device is ready.
• The Locator screen (Section 19.3 on page 184) allows users to see the actual location of the NWA1000
Series between several devices in the network.
19.2 Suppression Screen
The LED Suppression feature allows you to control how the LEDs of your NWA1000 Series behave after it’s
ready. The default LED suppression setting of your AP is different depending on your NWA1000 Series
model.
You can go to the Maintenance > LEDs > Suppression screen to see the default LED behavior and
change the LED suppression setting. After you make changes in the suppression screen, it will be stored
as the default when the NWA1000 Series is restarted. See (Section 3.1 on page 19) for information on
default values for different models.
Note: When the NWA1000 Series is booting or performing firmware upgrade, the LEDs will lit
regardless of the setting in LED suppression.
To access this screen, click Maintenance > LEDs > Suppression.
To Next Page
Loading...
