ZyXEL Communications NWA1000 Series - Page 73

Chapter 9 Network
NWA1000 Series User’s Guide
73
Figure 42 Configuration > Network > IP Setting
Each field is described in the following table.
Table 30 Configuration > Network > IP Setting
LABEL DESCRIPTION
IP Address
Assignment
Get
Automatically
Select this to make the interface a DHCP client and automatically get the IP address,
subnet mask, and gateway address from a DHCP server.
Use Fixed IP
Address
Select this if you want to specify the IP address, subnet mask, and gateway manually.
IP Address Enter the IP address for this interface.
Subnet Mask Enter the subnet mask of this interface in dot decimal notation. The subnet mask indicates
what part of the IP address is the same for all computers in the network.
Gateway Enter the IP address of the gateway. The NWA1000 Series sends packets to the gateway
when it does not know how to route the packet to its destination. The gateway should be
on the same network as the interface.
DNS Server IP
Address
Enter the IP address of the DNS server.
IPv6 Address
Assignment
Enable Stateless
Address Auto-
configuration
(SLAAC)
Select this to enable IPv6 stateless auto-configuration on the NWA1000 Series. The NWA1000
Series will generate an IPv6 address itself from a prefix obtained from an IPv6 router in the
network.