ZyXEL Communications NWA1000 Series - Page 168

Chapter 16 Log and Report
NWA1000 Series User’s Guide
168
Figure 107 Active Log Summary
This screen provides a different view and a different way of indicating which messages are included in
each log and each alert. The Default category includes debugging messages generated by open
source software.
The following table describes the fields in this screen.
Table 76 Configuration > Log & Report > Log Setting > Active Log Summary
LABEL DESCRIPTION
Active Log
Summary
System log Use the System Log drop-down list to change the log settings for all of the log categories.
disable all logs (red X) - do not log any information for any category for the system log or e-mail
any logs to e-mail server 1 or 2.
enable normal logs (green check mark) - create log messages and alerts for all categories for
the system log. If e-mail server 1 or 2 also has normal logs enabled, the NWA1000 Series will e-
mail logs to them.
enable normal logs and debug logs (yellow check mark) - create log messages, alerts, and
debugging information for all categories. The NWA1000 Series does not e-mail debugging
information, even if this setting is selected.