ZyXEL Communications NWA1000 Series - Page 20

Chapter 3 Hardware
NWA1000 Series User’s Guide
20
The following table describes the LEDs.
Table 2 NWA1123-AC PRO LEDs
LED COLOR STATUS DESCRIPTION
PWR/SYS Red Slow Blinking (On for 1
sec, Off for 1 sec)
The LED blinks orange and green alternatively when the
NWA1000 Series is booting up.
Green On
Green On The NWA1000 Series is ready for use.
Red On There is system error and the NWA1000 Series cannot
boot up, or the NWA1000 Series suffered a system failure.
Red Fast Blinking (On for 50
ms, Off for 50 ms)
The NWA1000 Series is doing firmware upgrade.
Red Slow Blinking (Blink for 3
times, Off for 3 sec)
The Uplink port is disconnected.
Green Slow Blinking (On for 1
sec, Off for 1 sec)
The wireless module of the NWA1000 Series is disabled or
failed.
Management Green/
Amber
Off The NWA1000 Series is in standalone mode.
WLAN Green On The antenna switch is set to “Ceiling” for the radio.
The 2.4 GHz WLAN is active.
Amber On The antenna switch is set to “Wall” for the radio.
The 2.4 GHz WLAN is active.
Off The 2.4 GHz WLAN is not active.
WLAN Green On The antenna switch is set to “Ceiling” for the radio.
The 5 GHz WLAN is active.
Amber On The antenna switch is set to “Wall” for the radio.
The 5 GHz WLAN is active.
Off The 5 GHz WLAN is not active.
UPLINK Amber/
Green
On Amber - The port is operating as a 100-Mbps connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The NWA1000 Series is sending/receiving data through
the port.
Off The port is not connected.
LAN Amber/
Green
On Amber - The port is operating as a 100-Mbps connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The LAN port is sending/receiving data through the port.
Off The LAN port is not connected.
Locator White Blinking The Locator is activated and will show the actual location
of the NWA1000 Series between several devices in the
network.
Off The Locator function is off.