ZyXEL Communications NWA1000 Series - Page 200

Chapter 26 Network
NWA1000 Series User’s Guide
200
Figure 127 Configuration > Network > IP Setting
Each field is described in the following table.
Table 88 Configuration > Network > IP Setting
LABEL DESCRIPTION
IP Address
Assignment
Get
Automatically
Select this to make the interface a DHCP client and automatically get the IP address,
subnet mask, and gateway address from a DHCP server.
Use Fixed IP
Address
Select this if you want to specify the IP address, subnet mask, and gateway manually.
IP Address Enter the IP address for this interface.
Subnet Mask Enter the subnet mask of this interface in dot decimal notation. The subnet mask indicates
what part of the IP address is the same for all computers in the network.
Gateway Enter the IP address of the gateway. The NWA1000 Series sends packets to the gateway
when it does not know how to route the packet to its destination. The gateway should be
on the same network as the interface.
DNS Server IP
Address
Enter the IP address of the DNS server.
Use Proxy to Access
Internet
If the NWA1000 Series is behind a proxy server, you need to select this option and configure
the proxy server settings so that the NWA1000 Series can access the NCC through the proxy
server.
Proxy Server Enter the IP address of the proxy server.
Proxy Port Enter service port number used by the proxy server.
Authentication Select this option if the proxy server requires authentication before it grants access to the
Internet.
User Name Enter your proxy user name.
Password Enter your proxy password.