Chapter 7 Dashboard
NWA1000 Series User’s Guide
54
Channel This field displays the channel number on the root AP or repeater to which the NWA1000
Series is connected using WDS.
SSID This field displays the name of the wireless network to which the NWA1000 Series is
connected using WDS.
Security Mode This field displays which secure encryption methods is being used by the NWA1000 Series to
connect to the root AP or repeater using WDS.
Link Status This field displays the RSSI (Received Signal Strength Indicator) and transmission/reception
rate of the wireless connection in WDS.
System Status
System Uptime This field displays how long the NWA1000 Series has been running since it last restarted or
was turned on.
Current Date/
Time
This field displays the current date and time in the NWA1000 Series. The format is yyyy-mm-
dd hh:mm:ss.
Current Login
User
This field displays the user name used to log in to the current session, the amount of
reauthentication time remaining, and the amount of lease time remaining.
Boot Status This field displays details about the NWA1000 Series’s startup state.
OK - The NWA1000 Series started up successfully.
Firmware update OK - A firmware update was successful.
Problematic configuration after firmware update - The application of the configuration
failed after a firmware upgrade.
System default configuration - The NWA1000 Series successfully applied the system default
configuration. This occurs when the NWA1000 Series starts for the first time or you
intentionally reset the NWA1000 Series to the system default settings.
Fallback to lastgood configuration - The NWA1000 Series was unable to apply the startup-
config.conf configuration file and fell back to the lastgood.conf configuration file.
Fallback to system default configuration - The NWA1000 Series was unable to apply the
lastgood.conf configuration file and fell back to the system default configuration file
(system-default.conf).
Booting in progress - The NWA1000 Series is still applying the system configuration.
Management
Mode
This shows whether the NWA1000 Series is set to work as a stand alone AP.
Power Mode This displays the NWA1000 Series’s power status.
Full - the NWA1000 Series receives power using a power adaptor and/or through a PoE
switch/injector using IEEE 802.3at PoE plus.
Limited - the NWA1000 Series receives power through a PoE switch/injector using IEEE
802.3af PoE even when it is also connected to a power source using a power adaptor.
When the NWA1000 Series is in limited power mode, the NWA1000 Series throughput
decreases and has just one transmitting radio chain.
It always shows Full if the NWA1000 Series does not support power detection. See Table 1 on
page 12.
Interface Status
Summary
If an Ethernet interface does not have any physical ports associated with it, its entry is
displayed in light gray text. Click the Detail icon to go to a (more detailed) summary screen
of interface statistics.
Name This field displays the name of each interface.
Table 19 Dashboard (continued)
LABEL DESCRIPTION
To Next Page
Loading...
