Chapter 12 AP Profile
NWA50AX User’s Guide
109
The following table describes the labels in this screen.
Table 44 Configuration > Object > AP Profile > SSID > Security List > Add/Edit Security Profile> Security
Mode: wep
LABEL DESC RIPTIO N
General Settings
Profile Name Enter up to 31 alphanumeric characters for the profile name. This name is only visible in
the Web Configurator and is only for management purposes. Spaces and underscores
are allowed.
Security Mode Select a security mode from the list: no ne , e nha nc e d - o pe n, we p, wpa 2, wpa 2- m ix or
wp a 3.
e nha nc e d - o pe n uses Opportunistic Wireless Encryption (OWE) which encrypts the
wireless connection when possible.
Authentication Settings
Authentication Type Select a WEP authentication method. Choices are O p e n or Sha re key.
Key Length Select the bit-length of the encryption key to be used in WEP connections.
If you select WEP- 64:
• Enter 10 hexadecimal digits in the range of “A-F”, “a-f” and “0-9” (for example,
0x11AA22BB33) for each Ke y used.
or
• Enter 5 ASCII characters (case sensitive) ranging from “a-z”, “A-Z” and “0-9” (for
example, MyKey) for each Ke y used.
If you select WEP- 128:
• Enter 26 hexadecimal digits in the range of “A-F”, “a-f” and “0-9” (for example,
0x00112233445566778899AABBCC) for each Ke y used.
or
• Enter 13 ASCII characters (case sensitive) ranging from “a-z”, “A-Z” and “0-9” (for
example, MyKey12345678) for each Ke y used.
Key 1~4 Based on your Ke y Le ng th selection, enter the appropriate length hexadecimal or ASCII
key.
Advance
Note: Click on the Sho w Adva nc e d Se tting s button to show the fields describe below.
Idle Timeout Enter the idle interval (in seconds) that a client can be idle before authentication is
discontinued.
OK Click O K to save your changes back to the Zyxel Device.
Cancel Click C a nc e l to exit this screen without saving your changes.
To Next Page
Loading...
