EasyManua.ls Logo

ZyXEL Communications NWA50AX - Page 111

ZyXEL Communications NWA50AX
256 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 12 AP Profile
NWA50AX User’s Guide
111
Cipher Type Select an encryption cipher type from the list.
a uto - This automatically chooses the best available cipher based on the cipher in
use by the wireless client that is attempting to make a connection.
a e s - This is the Advanced Encryption Standard encryption method. It is a more
recent development over TKIP and considerably more robust. Not all wireless clients
may support this.
Idle Timeout Enter the idle interval (in seconds) that a client can be idle before authentication is
discontinued.
Group Key Update
Timer
Enter the interval (in seconds) at which the AP updates the group WPA2 encryption key.
Pre-Authentication Select Ena b le to allow pre-authentication. Otherwise, select Disa b le .
Management Frame
Protection
This field is available only when you select wpa 2 in the Se c urity Mo d e field and set Ciphe r
Type to a e s.
Data frames in 802.11 WLANs can be encrypted and authenticated with WEP, WPA or
WPA2. But 802.11 management frames, such as beacon/probe response, association
request, association response, de-authentication and disassociation are always
unauthenticated and unencrypted. IEEE 802.11w Protected Management Frames allows
APs to use the existing security mechanisms (encryption and authentication methods
defined in IEEE 802.11i WPA/WPA2) to protect management frames. This helps prevent
wireless DoS attacks.
Select the check box to enable management frame protection (MFP) to add security to
802.11 management frames.
Select O p tio na l if you do not require the wireless clients to support MFP. Management
frames will be encrypted if the clients support MFP.
Select Re q uire d and wireless clients must support MFP in order to join the Zyxel Device’s
wireless network.
OK Click O K to save your changes back to the Zyxel Device.
Cancel Click C a nc e l to exit this screen without saving your changes.
Table 45 Configuration > Object > AP Profile > SSID > Security List > AAdd/Edit Security Profile> Security
Mode: wpa2 (continued)
LABEL DESC RIPTIO N

Table of Contents

Related product manuals