Chapter 5 WAN Setup
P-870HN-5xb User’s Guide
89
IPoA
Figure 39 This screen displays only when you set the DSL link type to IPoA for
the ATM interface and configure a WAN connection using the ATM interface.
The following table describes the labels in this screen.
WAN IPv6
Subnet Prefix
Length
Enter the bit number of the IPv6 subnet mask provided by your ISP.
Static WAN
Gateway IPv6
Address
Enter the gateway IPv6 address provided by your ISP.
6RD (6to4
Tunneling)
Select this option to enable IPv6 to IPv4 tunneling. This will
encapsulate IPv6 to IPv4 packets.
Select Set by DCHP if you want to obtain a 6RD endpoint IP address
from a DHCP server. Select Manual Setting to specify the 6RD
endpoint IP address manually.
6RD Endpoint
IP Address
If you enabled 6RD, specify the 6RD endpoint IP address.
6RD IPv6
Prefix
If you enabled 6RD, specify the IPv6 prefix for the endpoint IP
address.
Back Click this button to return to the previous screen.
Next Click this button to continue.
Table 18 WAN Configuration: IPoA
LABEL DESCRIPTION
WAN IP Address Enter the static IP address provided by your ISP.
WAN Subnet
Mask
Enter the subnet mask provided by your ISP.
Unnumbered
Mode
Select this if your ISP provided a range of static public IP addresses
for you to use.
Gateway IP
Address
Enter the Device’s WAN IP address.
Table 17 WAN Configuration: IPoE
LABEL DESCRIPTION
To Next Page
Loading...
