Chapter 7 Monitor
ZyWALL USG Series User’s Guide
207
7.5 The Session Monitor Screen
The Session Monitor screen displays all established sessions that pass through the Zyxel Device for
debugging or statistical analysis. It is not possible to manage sessions in this screen. The following
information is displayed.
• User who started the session
• Protocol or service port used
• Source address
• Destination address
• Number of bytes received (so far)
• Number of bytes transmitted (so far)
• Duration (so far)
You can look at all established sessions that passed through the Zyxel Device by user, service, source IP
address, or destination IP address. You can also filter the information by user, protocol / service or service
group, source address, and/or destination address and view it by user.
Click Monitor > System Status > Session Monitor to display the following screen.
Figure 171 Monitor > System Status > Session Monitor
Byte Count Limit 2
64
bytes; this is just less than 17 million terabytes.
Hit Count Limit 2
64
hits; this is over 1.8 x 10
19
hits.
Table 40 Maximum Values for Reports (continued)
LABEL DESCRIPTION
To Next Page
Loading...
