Chapter 43 Object
ZyWALL USG Series User’s Guide
897
43.14 SSL Application Overview
You use SSL application objects in SSL VPN. Configure an SSL application object to specify the type of
application and the address of the local computer, server, or web site SSL users are to be able to
access. You can apply one or more SSL application objects in the VPN > SSL VPN screen for a user
account/user group.
The ZyWALL VPN models do not support SSL Application.
• Use the SSL Application screen (Section 43.14.2 on page 899) to view the Zyxel Device’s configured
SSL application objects.
• Use the SSL Application Edit screen to create or edit web-based application objects to allow remote
users to access an application via standard web browsers (Section 43.14.2.1 on page 900).
• You can also use the SSL Application Edit screen to specify the name of a folder on a Linux or
Windows file server which remote users can access using a standard web browser (Section 43.14.2.1
on page 900).
43.14.1 What You Need to Know
Application Types
You can configure the following SSL application on the Zyxel Device.
•Web-based
A web-based application allows remote users to access an intranet site using standard web browsers.
Server IP If this ISP account uses the PPPoE protocol, this field is not displayed.
If this ISP account uses the PPTP protocol, type the IP address of the PPTP server.
Connection ID This field is available if this ISP account uses the PPTP protocol. Type your identification name for
the PPTP server. This field can be blank.
Service Name If this ISP account uses the PPPoE protocol, type the PPPoE service name to access. PPPoE uses
the specified service name to identify and reach the PPPoE server. This field can be blank.
If this ISP account uses the PPTP protocol, this field is not displayed.
Compression Select On button to turn on stac compression, and select Off to turn off stac compression. Stac
compression is a data compression technique capable of compressing data by a factor of
about four.
Idle Timeout This value specifies the number of seconds that must elapse without outbound traffic before
the Zyxel Device automatically disconnects from the PPPoE/PPTP server. This value must be an
integer between 0 and 360. If this value is zero, this timeout is disabled.
OK Click OK to save your changes back to the Zyxel Device. If there are no errors, the program
returns to the ISP Account screen. If there are errors, a message box explains the error, and the
program stays in the ISP Account Edit screen.
Cancel Click Cancel to return to the ISP Account screen without creating the profile (if it is new) or
saving any changes to the profile (if it already exists).
Table 355 Configuration > Object > ISP Account > Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
