Chapter 10 Interfaces
ZyWALL USG Series User’s Guide
397
10.14 The Trunk Summary Screen
Click Configuration > Network > Interface > Trunk to open the Trunk screen. The Trunk Summary screen
lists the configured trunks and the load balancing algorithm that each is configured to use.
Figure 278 Configuration > Network > Interface > Trunk
The following table describes the items in this screen.
Table 131 Configuration > Network > Interface > Trunk
LABEL DESCRIPTION
Show Advanced
Settings / Hide
Advanced Settings
Click this button to display a greater or lesser number of configuration fields.
Configuration Configure what to do with existing passive mode interface connections when an
interface set to active mode in the same trunk comes back up.
Disconnect
Connections Before
Falling Back
Select this to terminate existing connections on an interface which is set to passive mode
when any interface set to active mode in the same trunk comes back up.
Enable Default SNAT Select this to have the Zyxel Device use the IP address of the outgoing interface as the
source IP address of the packets it sends out through its WAN trunks. The Zyxel Device
automatically adds SNAT settings for traffic it routes from internal interfaces to external
interfaces.
Default Trunk Selection Select whether the Zyxel Device is to use the default system WAN trunk or one of the user
configured WAN trunks as the default trunk for routing traffic from internal interfaces to
external interfaces.
User Configuration /
System Default
The Zyxel Device automatically adds all external interfaces into the pre-configured
system default SYSTEM_DEFAULT_WAN_TRUNK. You cannot delete it. You can create your
own User Configuration trunks and customize the algorithm, member interfaces and the
active/passive mode.
Add Click this to create a new user-configured trunk.
To Next Page
Loading...
