Chapter 7 Monitor
ZyWALL USG Series User’s Guide
264
7.37.3 Dynamic Users Log
Use this screen to view the Zyxel Device’s dynamic guest account log messages. Click Monitor > Log >
Dynamic Users Log to access this screen.
Figure 219 Monitor > Log > Dynamic Users Log
Destination Address Type the IP ad re ss of the destination.
Destination Interface Select the destination interface from the pull down menu.
Keyword Type a keyword of the policy service available from
Zyxel Device to search for a log.
Search Click this to start the search.
Email Log Now Click this button to send log message(s) to the Active e-mail address(es) specified in the
Send Log To field on the Log Settings page.
Refresh Click this button to update the information in the screen.
Clear Log Click this button to clear the whole log, regardless of what is currently displayed on the
screen.
# This field is a sequential value, and it is not associated with a specific log message.
Time This field displays the time the log message was recorded.
Priority This displays when you show the filter. Select the priority of log messages to display. The
log displays the log messages with this priority or higher. Choices are: any, emerg, alert,
crit, error, warn, notice, and info, from highest priority to lowest priority. This field is read-
only if the Category is Debug Log.
Category This field displays the log that generated the log message. It is the same value used in
the Display and (other) Category fields.
Message This field displays the message of the log.
Source This displays the source IP address of the selected log message.
Destination This displays the source IP address of the selected log message.
Note This field displays any additional information about the log message.
Table 84 Monitor > Log > View AP Log (continued)
LABEL DESCRIPTION
To Next Page
Loading...
