Chapter 10 Interfaces
ZyWALL USG Series User’s Guide
349
Figure 261 6to4 Tunnel
10.8.1 Configuring a Tunnel
This screen lists the Zyxel Device’s configured tunnel interfaces. To access this screen, click Network >
Interface > Tunnel.
Figure 262 Network > Interface > Tunnel
Each field is explained in the following table.
Internet
IPv6
IPv4
IPv6
IPv6
Table 117 Network > Interface > Tunnel
LABEL DESCRIPTION
Add Click this to create a new GRE tunnel interface.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to
remove it before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
References Select an entry and click References to open a screen that shows which settings use the
entry. See Section 10.5.4 on page 328 for an example.
# This field is a sequential value, and it is not associated with any interface.
To Next Page
Loading...
