Chapter 30 IPSec VPN
ZyWALL USG Series User’s Guide
612
30.2.1 The VPN Connection Add/Edit Screen
The VPN Connection Add/Edit Gateway screen allows you to create a new VPN connection policy or
edit an existing one. To access this screen, go to the Configuration > VPN Connection screen (see
Section 30.2 on page 610), and click either the Add icon or an Edit icon.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove it
before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Connect To connect an IPSec SA, select it and click Connect.
Disconnect To disconnect an IPSec SA, select it and click Disconnect.
Reference Select an entry and click References to open a screen that shows which settings use the entry.
See Section 10.5.4 on page 328 for an example.
# This field is a sequential value, and it is not associated with a specific connection.
Status The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is
inactive.
The connect icon is lit when the interface is connected and dimmed when it is disconnected.
Name This field displays the name of the IPSec SA.
VPN Gateway This field displays the VPN gateway in use for this VPN connection.
Gateway IP
Version
This field displays what IP version the associated VPN gateway(s) is using. An IPv4 gateway may
use an IKEv1 or IKEv2 SA. An IPv6 gateway may use IKEv2 only.
Policy This field displays the local policy and the remote policy, respectively.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
Table 220 Configuration > VPN > IPSec VPN > VPN Connection (continued)
LABEL DESCRIPTION
To Next Page
Loading...
