Chapter 3 Hardware, Interfaces and Zones
ZyWALL USG Series User’s Guide
74
Note: Use an 8-wire Ethernet cable to run your Gigabit Ethernet connection at 1000 Mbps.
Using a 4-wire Ethernet cable limits your connection to 100 Mbps. Note that the
connection speed also depends on what the Ethernet device at the other end can
support.
3.2 Mounting
Some models can be mounted in a rack, and some can be mounted on a wall and some, both.
3.2.1 Rack-mounting
See Table 15 on page 74 for the Zyxel Device models that can be rack mounted. Use the following steps
to mount the Zyxel Device on an EIA standard size, 19-inch rack or in a wiring closet with other
equipment using a rack-mounting kit. Make sure the rack will safely support the combined weight of all
the equipment it contains and that the position of the ZyWALL does not make the rack unstable or top-
heavy. Take all necessary precautions to anchor the rack securely before installing the unit.
Note: Leave 10 cm of clearance at the sides and 20 cm in the rear.
Use a #2 Phillips screwdriver to install the screws.
Note: Failure to use the proper screws may damage the unit.
1 Align one bracket with the holes on one side of the Zyxel Device and secure it with the included bracket
screws (smaller than the rack-mounting screws).
2 Attach the other bracket in a similar fashion.
Table 15 Mounting Method
RACK-MOUNTING WALL-MOUNTING
• ZyWALL 110 • USG20-VPN
• ZyWALL 310 • USG20W-VPN
•ZyWALL 1100 •USG40
•USG110 •USG40W
•USG210 •USG60
•USG310 •USG60W
• USG1100
• USG1900
• USG2200-VPN
• USG2200
To Next Page
Loading...
