Chapter 11 Routing
ZyWALL USG Series User’s Guide
423
1 Enable OSPF.
2 Set up the OSPF areas.
3 Configure the appropriate interfaces. See Section 10.5.1 on page 306.
4 Set up virtual links, as needed.
11.7.1 Configuring the OSPF Screen
Use the first OSPF screen to specify the OSPF router the Zyxel Device uses in the OSPF AS and maintain
the policies for redistribution. In addition, it provides a summary of OSPF areas, allows you to remove
them, and opens the OSPF Add/Edit screen to add or edit them.
Click Configuration > Network > Routing > OSPF to open the following screen.
Figure 293 Configuration > Network > Routing > OSPF
The following table describes the labels in this screen. See Section 11.7.2 on page 424 for more
information as well.
Table 145 Configuration > Network > Routing Protocol > OSPF
LABEL DESCRIPTION
OSPF Router ID Select the 32-bit ID the Zyxel Device uses in the OSPF AS.
Default - the first available interface IP address is the Zyxel Device’s ID.
User Defined - enter the ID (in IP address format) in the field that appears when you select
User Define.
Redistribute
Active RIP Select this to advertise routes that were learned from RIP. The Zyxel Device advertises
routes learned from RIP to Normal and NSSA areas but not to Stub areas.
To Next Page
Loading...
