ZyXEL Communications USG210 - The Dhcpv6 Lease Screen

Chapter 43 Object
ZyWALL USG Series User’s Guide
904
43.15.2 The DHCPv6 Lease Screen
The Lease screen allows you to add, edit, and remove DHCPv6 lease type objects. To access this screen,
login to the Web Configurator, and click Configuration > Object > DHCPv6 > Lease.
Figure 631 Configuration > Object > DHCPv6 > Lease
The following table describes the labels in this screen.
43.15.2.1 DHCPv6 Lease Add/Edit Screen
The Lease Add/Edit screen allows you to create a new lease object or edit an existing one.
To access this screen, go to the Lease screen (see Section 43.15.2 on page 904), and click either the
Add icon or an Edit icon.
Interface Select the interface for this request object.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving your changes.
Table 359 Configuration > DHCPv6 > Request > Add (continued)
LABEL DESCRIPTION
Table 360 Configuration > Object > DHCPv6 > Lease
LABEL DESCRIPTION
Configuration
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove
it before doing so.
References Select an entry and click References to open a screen that shows which settings use the entry.
# This field is a sequential value, and it is not associated with a specific object.
Name This field displays the name of each lease object.
Type This field displays the request type of each lease object.
Interface This field displays the interface used for each lease object.
Value This field displays the value for each lease object.