Chapter 43 Object
ZyWALL USG Series User’s Guide
850
Figure 588 Geo IP > Add
The following table describes the labels in this screen.
43.8 Service Overview
Use service objects to define TCP applications, UDP applications, and ICMP messages. You can also
create service groups to refer to multiple service objects in other features.
• Use the Service screens (Section 43.8.2 on page 851) to view and configure the Zyxel Device’s list of
services and their definitions.
• Use the Service Group screens (Section 43.8.2 on page 851) to view and configure the Zyxel Device’s
list of service groups.
43.8.1 What You Need to Know
IP Protocols
IP protocols are based on the eight-bit protocol field in the IP header. This field represents the next-level
protocol that is sent in this packet. This section discusses three of the most common IP protocols.
Table 329 Geo IP > Add
LABEL DESCRIPTION
Region Select the country or continent that maps to this IP address.
Address Type Select the type of address you want to create. Choices are: HOST, RANGE, SUBNET.
IP Address This field is only available if the Address Type is HOST. This field cannot be blank. Enter the IP
address that this address object represents.
IP Starting
Address
This field is only available if the Address Type is RANGE. This field cannot be blank. Enter the
beginning of the range of IP addresses that this address object represents.
IP Ending Address This field is only available if the Address Type is RANGE. This field cannot be blank. Enter the end
of the range of IP address that this address object represents.
Network /
Netmask
These fields are only available if the IPv4 Address Type is SUBNET. They cannot be blank. Enter
the network IP and subnet mask that defines the IPv4 subnet.
IPv6 Address
Prefix
This field is only available if the IPv6 Address Type is SUBNET. This field cannot be blank. Enter the
IPv6 address prefix that the Zyxel Device uses for the LAN IPv6 address.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving your changes.
To Next Page
Loading...
