Chapter 10 Interfaces
ZyWALL USG Series User’s Guide
332
Figure 254 Configuration > Network > Interface > PPP
Each field is described in the table below.
Table 112 Configuration > Network > Interface > PPP
LABEL DESCRIPTION
User Configuration /
System Default
The Zyxel Device comes with the (non-removable) System Default PPP interfaces pre-
configured. You can create (and delete) User Configuration PPP interfaces. System Default
PPP interfaces vary by model.
Add Click this to create a new user-configured PPP interface.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove a user-configured PPP interface, select it and click Remove. The Zyxel Device
confirms you want to remove it before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Connect To connect an interface, select it and click Connect. You might use this in testing the
interface or to manually establish the connection for a Dial-on-Demand PPPoE/PPTP
interface.
Disconnect To disconnect an interface, select it and click Disconnect. You might use this in testing the
interface.
References Select an entry and click References to open a screen that shows which settings use the
entry. See Section 10.5.4 on page 328 for an example.
# This field is a sequential value, and it is not associated with any interface.
Status The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is
inactive.
The connect icon is lit when the interface is connected and dimmed when it is
disconnected.
Name This field displays the name of the interface.
Description This field displays the description of the interface.
Base Interface This field displays the interface on the top of which the PPPoE/PPTP/L2TP interface is.
To Next Page
Loading...
