Chapter 1 Introduction
ZyWALL USG Series User’s Guide
37
If you select Never and you later want to bring this screen back, use these commands (note the space
before the underscore).
See the Command Line Interface (CLI) Reference Guide (RG) for details on all supported commands.
7 Follow the directions in the Update Admin Info screen. If you change the default password, the Login
screen appears after you click Apply. If you click Ignore, the Installation Setup Wizard opens if the
ZyWALL is using its default configuration; otherwise the dashboard appears.
Router> enable
Router#
Router# configure terminal
Router(config)#
Router(config)# service-register _setremind
after-10-days
after-180-days
after-30-days
every-time
never
Router(config)# service-register _setremind every-time
Router(config)#
To Next Page
Loading...
