Chapter 11 Routing
ZyWALL USG Series User’s Guide
409
Figure 283 Configuration > Network > Routing > Policy Route
The following table describes the labels in this screen.
Table 137 Configuration > Network > Routing > Policy Route
LABEL DESCRIPTION
Show Advanced
Settings / Hide
Advanced Settings
Click this button to display a greater or lesser number of configuration fields.
Enable BWM This is a global setting for enabling or disabling bandwidth management on the Zyxel
Device. You must enable this setting to have individual policy routes or application patrol
policies apply bandwidth management.
This same setting also appears in the AppPatrol > General screen. Enabling or disabling it
in one screen also enables or disables it in the other screen.
IPv4 Configuration /
IPv6 Configuration
Use the IPv4 Configuration section for IPv4 network settings. Use the IPv6 Configuration
section for IPv6 network settings if you connect your Zyxel Device to an IPv6 network. Both
sections have similar fields as described below.
Use IPv4/IPv6 Policy
Route to Override
Direct Route
Select this to have the Zyxel Device forward packets that match a policy route according
to the policy route instead of sending the packets directly to a connected network.
Add Click this to create a new entry. Select an entry and click Add to create a new entry after
the selected entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify
the entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to
remove it before doing so.
To Next Page
Loading...
