Chapter 11 Routing
ZyWALL USG Series User’s Guide
429
Figure 298 Configuration > Network > Routing > BGP
The following table describes the labels in this screen.
Table 148 Configuration > Network > Routing Protocol > BGP
LABEL DESCRIPTION
AS Number Type a number from 1 to 4294967295 in this field.
Note: The Zyxel Device can only belong to one AS at a time.
Router ID Type the IP address of the interface on the Zyxel Device. This field is optional.
Redistribute Select Connected to redistribute routes of directly attached devices to the Zyxel Device
into the BGP Routing Information Base (RIB).
Neighbors This section displays information about peer BGP routers in neighboring AS’.
Note: The maximum number of neighboring BGP routers supported by the Zyxel
Device is 5.
Add Click this to configure BGP criteria for a new peer BGP router.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify
the entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to
remove it before doing so.
# This field is a sequential value, and it is not associated with a specific area.
IP Address This displays the IPv4 address of the peer BGP router in a neighboring AS.
AS Number This displays the AS Number of the peer BGP router in a neighboring AS.
Network Use this section to add routes that will be announced to all BGP neighbors.
Note: You may configure up to 16 network routes.
Add Click this to configure network information for a new route.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify
the entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to
remove it before doing so.
# This field is a sequential value, and it is not associated with a specific area.
To Next Page
Loading...
