Chapter 30 IPSec VPN
ZyWALL USG Series User’s Guide
630
• A subnet or range remote policy
The following VPN Gateway rules configured on the Zyxel Device cannot be provisioned to the IPSec
VPN Client:
• IPv4 rules with IKEv2 version
• IPv4 rules with User-based PSK authentication
Note: You must enable IPv6 in System > IPv6 to activate IPv6 VPN tunneling rules.
In the Zyxel Device Quick Setup wizard, you can use the VPN Settings for Configuration Provisioning
wizard to create a VPN rule that will not violate these restrictions.
Figure 437 Configuration > VPN > IPSec VPN > Configuration Provisioning
Each field is discussed in the following table.
Table 226 Configuration > VPN > IPSec VPN > Configuration Provisioning
LABEL DESCRIPTION
Enable
Configuration
Provisioning
Select this for users to be able to retrieve VPN rule settings using the Zyxel Device IPSec VPN
client.
Client
Authentication
Method
Choose how users should be authenticated. They can be authenticated using the local
database on the Zyxel Device or an external authentication database such as LDAP, Active
Directory or RADIUS. default is a method you configured in Object > Auth Method. You may
configure multiple methods there. If you choose the local database on the Zyxel Device, then
configure users using the Object > User/Group screen. If you choose LDAP, Active Directory or
RADIUS authentication servers, then configure users on the respective server.
Configuration When you add or edit a configuration provisioning entry, you are allowed to set the VPN
Connection and Allowed User fields.
Duplicate entries are not allowed. You cannot select the same VPN Connection and Allowed
User pair in a new entry if the same pair exists in a previous entry.
You can bind different rules to the same user, but the Zyxel Device will only allow VPN rule setting
retrieval for the first match found.
To Next Page
Loading...
