Chapter 43 Object
ZyWALL USG Series User’s Guide
876
Go to Configuration > Object > Auth. Method > Two-factor Authentication > Admin Access and
configure the following screen as shown.
Figure 610 Configuration > Object > Auth. Method > Two-factor Authentication > Admin Access
The following table describes the labels in this screen.
Table 346 Configuration > Object > Auth. Method > Two-factor Authentication > Admin Access
LABEL DESCRIPTION
General Settings
Enable Select the check box to require double-layer security to access a secured network behind the
Zyxel Device via the Web Configurator, SSH, or Telnet.
Valid Time Enter the maximum time (in minutes) that the user must click or tap the authorization link in the
SMS or email in order to get authorization for logins via the Web Configurator, SSH, or Telnet.
Two-factor
Authentication
for Services:
Select which services require Two-Factor Authentication for the admin user.
•Web
•SSH
•TELNET
User/Group This list displays the names of the users and user groups that can be selected for two-factor
authentication. The order of members is not important. Select users and groups from the
Selectable User/Group Objects list that require two-factor authentication for VPN access to a
secured network behind the Zyxel Device and move them to the Selected User/Group Objects
list. You can double-click a single entry to move it or use the [Shift] or [Ctrl] key to select multiple
entries and use the arrow button to move them.
Similarly, move user/groups that do not you do not require two-factor authentication back to
the Selectable User/Group Objects list.
Delivery Settings Use this section to configure how to send an SMS or email for authorization.
To Next Page
Loading...
