Chapter 44 System
ZyWALL USG Series User’s Guide
961
Figure 687 ZON Utility Screen
6 Select a device and then use the icons to perform actions.
Note: Some functions may not be available for your devices.
The following table describes the icons numbered from left to right in the ZON Utility screen.
Table 389 ZON Utility Icons
ICON DESCRIPTION
1 IP configuration Change the selected device’s IP address.
2 Renew IP Address Update a DHCP-assigned dynamic IP address.
3 Reboot Device Use this icon to restart the selected device(s). This may be useful when troubleshooting
or upgrading new firmware.
4 Reset Configuration to
Default
If you forget your password or cannot access the Web Configurator, you can use this
icon to reload the factory-default configuration file. This means that you will lose all
configurations that you had previously.
5 Locator LED Use this icon to locate the selected device by causing its Locator LED to blink.
6 Web GUI Use this to access the selected device web configurator from your browser. You will
need a username and password to log in.
7 Firmware Upgrade Use this icon to upgrade new firmware to selected device(s) of the same model. Make
sure you have downloaded the firmware from the Zyxel website to your computer and
unzipped it in advance.
If your Zyxel Device supports dual firmware images, the standby image will be
upgraded. After the new firmware is uploaded, you Zyxel Device will reboot, and the
new firmware will be the running firmware.
8 Change Password Use this icon to change the admin password of the selected device. You must know
the current admin password before changing to a new one.
To Next Page
Loading...
