Chapter 6 Broadband
VMG1312-B Series User’s Guide
91
6.2.1.2 Bridge Mode
Click the Add ne w W AN I nt er face in the N et w or k Set t ing > Br oadband screen or t he Edit icon
next to the connect ion you want to configure. Select Bridge as t he encapsulat ion m ode. The screen
varies depending on the interface t ype you select.
I Pv6 DNS Select D y n a m ic t o have t he Device get the I Pv6 DNS server addr esses from the I SP
aut om atically.
Select Stat ic t o have the Device use the I Pv6 DNS server addresses you configure
m anually.
I Pv6 DNS
Server 1
Ent er the first I Pv6 DNS ser ver address assigned by t he I SP.
I Pv6 DNS
Server 2
Ent er t he second I Pv6 DNS server address assigned by t he I SP.
VLAN These fields appear when t he Type is set t o ADSL/ VD SL over PTM.
Active Select t his option t o add t he VLAN t ag (specified below) t o the outgoing traffic through t his
connection.
802.1p I EEE 802.1p defines up to 8 separat e traffic t ypes by inser t ing a tag int o a MAC- layer fram e
that contains bits to define class of serv ice.
Select t he I EEE 802.1p priority level (from 0 t o 7) t o add t o t raffic t hrough t his connect ion.
The great er the num ber, t he higher the prior it y level.
802.1q Type t he VLAN I D num ber ( from 1 to 4094) for traffic t hrough this connect ion.
QoS
Rat e Lim it Enter the rate lim it for the connect ion. This is the m axim um transm ission rat e allowed for
traffic on t his connect ion.
MTU
MTU Size Enter the MTU (Maxim um Transfer Unit) size for this t raffic.
Apply Click Apply t o save your changes back t o t he Device.
Cancel Click Ca n cel t o exit t his screen w it hout saving.
Table 8 Routing Mode (cont inued)
LABEL DESCRIPTION
To Next Page
Loading...
