ZyXEL Communications VMG3925-B10C - The Parental Control Screen

Chapter 5 Connection Status Screens
VMG/XMG Series User’s Guide
115
Figure 70 LAN Setup
Each field is described in the following table.
5.7 The Parental Control Screen
Use this screen to view the number of profiles that were created for parental control.
Table 25 Status Screen
LABEL DESCRIPTION
LAN IP Setup
IP Address Type the LAN IPv4 IP address you want to assign to your Zyxel Device in dotted decimal
notation, for example, 192.168.1.1 (factory default).
Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example 255.255.255.0
(factory default). Your Zyxel Device automatically computes the subnet mask based on the
IP address you enter, so do not change this field unless you are instructed to do so.
IP Addressing Values
Beginning IP
Address
This field specifies the first of the contiguous addresses in the IP address pool.
Ending IP
Address
This field specifies the last of the contiguous addresses in the IP address pool.
DHCP Server State
DHCP Server
Lease Time
This is the period of time DHCP-assigned addresses is used. DHCP automatically assigns IP
addresses to clients when they log in. DHCP centralizes IP address management on central
computers that run the DHCP server program. DHCP leases addresses, for a period of time,
which means that past addresses are “recycled” and made available for future
reassignment to other systems.
Days/Hours/
Minutes
Type the lease time of the DHCP server.
Save Click Save to save your changes.