Chapter 8 Home Networking
VMG/XMG Series User’s Guide
198
8.6 The STB Vendor ID Screen
Use this screen to configure the Vendor IDs of connected Set Top Boxes (STBs) so the Zyxel Device can
automatically create static DHCP entries for them when they request IP addresses.
Click Network Setting > Home Networking > STB Vendor ID to open this screen.
Figure 117 Network Setting > Home Networking > STB Vendor ID
The following table describes the labels in this screen.
8.7 The Wake on LAN Screen
Use this screen to remotely turn on a device on the LAN network. Wake on LAN (WoL) allows you to
remotely turn on a device on the network, such as a computer, storage device or media server. To use
this feature the remote hardware (for example the network adapter on a computer) must support Wake
On LAN using the ‘Magic Packet’ method.
Offer Public IP
by DHCP
Click this switch to enable or disable the Zyxel Device to provide public IP addresses by DHCP
server. When the switch goes to the right , the function is enabled. Otherwise, it’s not.
Enable ARP
Proxy
Click this switch to enable or disable the ARP (Address Resolution Protocol) proxy. When the
switch goes to the right , the function is enabled. Otherwise, it’s not.
Cancel
Click Cancel to exit this screen without saving.
Apply Click Apply to save your changes.
Table 56 Network Setting > Home Networking > Additional Subnet (continued)
LABEL DESCRIPTION
Table 57 Network Setting > Home Networking > STB Vendor ID
LABEL DESCRIPTION
Vendor ID 1~5 These are STB’s Vendor Class Identifiers (DHCP option 60). A Vendor Class Identifier is usually
used to inform the DHCP server a DHCP client’s vendor and functionality.
Cancel
Click Cancel to exit this screen without saving.
Apply Click Apply to save your changes.
To Next Page
Loading...
