Chapter 8 Home Networking
VMG/XMG Series User’s Guide
191
8.4 The UPnP Screen
Universal Plug and Play (UPnP) is an open networking standard that uses TCP/IP for simple peer-to-peer
network connectivity between networking devices or software applications which have UPnP enabled.
A UPnP device can dynamically join a network, obtain an IP address, advertises its services, and learn
about other devices on the network. A device can also leave a network automatically when it is no
longer in use.
See Section 8.4.1 on page 192 for more information on UPnP.
Use the following screen to configure the UPnP settings on your Zyxel Device. Click Network Setting >
Home Networking > UPnP to display the screen shown next.
Note: To use UPnP NAT-T, enable NAT in the Network Setting > Broadband > Edit/Add New
WAN Interface screen.
Figure 115 Network Setting > Home Networking > UPnP
Select Device Info Select a device or computer from the drop-down list or select Manual Input to manually enter
a device’s MAC address and IP address in the following fields.
MAC Address If you select Manual Input, enter the MAC address of a computer on your LAN.
IP Address If you select Manual Input, enter the IP address that you want to assign to the computer on
your LAN with the MAC address that you will also specify.
Cancel
Click Cancel to exit this screen without saving.
OK Click OK to save your changes.
Table 54 Static DHCP: Static DHCP Configuration/Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
