EasyManua.ls Logo

ZyXEL Communications VMG3925-B10C - Leds (Lights)

ZyXEL Communications VMG3925-B10C
434 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 1 Introducing the Zyxel Device
VMG/XMG Series User’s Guide
33
Figure 24 VMG1312-T20B Front Panel
1.4.2 LEDs (Lights)
None of the LEDs are on if the Zyxel Device is not receiving power.
Table 4 VMG1312-B10D LED Descriptions
LED COLOR STATUS DESCRIPTION
POWER Green On The Zyxel Device is receiving power and ready for use.
Blinking The Zyxel Device is self-testing.
Red On The Zyxel Device detected an error while self-testing, or there is a device
malfunction.
Off The Zyxel Device is not receiving power.
DSL Green On The DSL line is up.
Blinking The Zyxel Device is initializing the DSL line.
Off The DSL line is down.
INTERNET Green On The Zyxel Device has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a DHCP
server), PPP negotiation was successfully completed (if used) and the DSL
connection is up.
Blinking The Zyxel Device is sending or receiving IP traffic.
Off There is no Internet connection or the gateway is in bridged mode.
Red On The Zyxel Device attempted to make an IP connection but failed. Possible
causes are no response from a DHCP server, no PPPoE response, PPPoE
authentication failed.

Table of Contents

Other manuals for ZyXEL Communications VMG3925-B10C

Related product manuals