Chapter 9 Routing
VMG/XMG Series User’s Guide
207
Figure 125 DNS Route Add
The following table describes the labels in this screen.
9.4 The Policy Route Screen
By default, the Zyxel Device routes packets based on the shortest path to the destination address. Policy
routes allow you to override the default behavior and route packets based on other criteria, such as the
source address.
For example, you can use policy-based routing to direct traffic from specific users through specific
connections or distribute traffic across multiple paths for load sharing. Policy-based routing is applied to
outgoing packets before the default routing rules are applied
The Policy Route screen let you view and configure routing policies on the Zyxel Device. Click Network
Setting > Routing > Policy Route to open the following screen.
Figure 126 Network Setting > Routing > Policy Route
Table 63 DNS Route Add
LABEL DESCRIPTION
Active Click this switch to enable or disable the DNS route. When the switch goes to the right , the
function is enabled. Otherwise, it is not.
Domain Name Enter the domain name of the DNS route entry.
Subnet Mask Enter the subnet mask of the DNS route entry.
WAN Interface Select the WAN connection through which the Zyxel Device forwards DNS requests for this
domain name. WWAN means the wireless cellular interface.
Cancel Click this to exit this screen without saving any changes.
OK Click this to save your changes.
To Next Page
Loading...
