Chapter 10 Quality of Service (QoS)
VMG/XMG Series User’s Guide
217
10.4.1 Adding a QoS Queue
Click Add New Queue or the Edit icon in the Queue Setup screen to configure a queue.
Figure 132 Queue Setup: Add
The following table describes the labels in this screen.
Rate Limit This shows the maximum transmission rate allowed for traffic on this queue. Rate limit 0 means
there's no rate limit on this queue.
Modify Click the Edit icon to edit the queue.
Click the Delete icon to delete an existing queue. Note that subsequent rules move up by one
when you take this action.
Table 68 Network Setting > QoS > Queue Setup (continued)
LABEL DESCRIPTION
Table 69 Queue Setup: Add
LABEL DESCRIPTION
Active Click this switch to enable or disable the queue. When the switch turns blue , the function is
enabled. Otherwise, it’s not.
Name Enter the descriptive name of this queue.
Interface Select the interface to which this queue is applied.
This field is read-only if you are editing the queue.
Priority Select the priority level (from 1 to 7) of this queue.
The smaller the number, the higher the priority level. Traffic assigned to higher priority queues
gets through faster while traffic in lower priority queues is dropped if the network is congested.
Weight Select the weight (from 1 to 8) of this queue.
If two queues have the same priority level, the Zyxel Device divides the bandwidth across the
queues according to their weights. Queues with larger weights get more bandwidth than
queues with smaller weights.
To Next Page
Loading...
