Chapter 6 Broadband
VMG/XMG Series User’s Guide
130
6.2.1.2 Bridge Mode
Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon next to the
connection you want to configure. Select Bridge as the encapsulation mode. The screen varies
depending on the interface type you select.
If you select ADSL/VDSL over PTM or Ethernet as the interface type, the following screen appears.
Figure 82 Network Setting > Broadband > Add/Edit New WAN Interface (ADSL/VDSL over PTM or
Ethernet-Bridge Mode)
The following table describes the fields in this screen.
If you select ADSL over ATM as the interface type, the following screen appears.
Table 32 Network Setting > Broadband > Add/Edit New WAN Interface (ADSL/VDSL over PTM or
Ethernet-Bridge Mode)
LABEL DESCRIPTION
General Click this switch to enable or disable the interface. When the switch goes to the right , the
function is enabled. Otherwise, it is not.
Name Enter a service name of the connection.
Type Select ADSL/VDSL over PTM as the interface that you want to configure. The Zyxel Device uses the
VDSL technology for data transmission over the DSL port.
Mode Select Bridge when your ISP provides you more than one IP address and you want the connected
computers to get individual IP address from ISP’s DHCP server directly. If you select Bridge, you
cannot use routing functions, such as QoS, Firewall, DHCP server and NAT on traffic from the
selected LAN port(s).
VLAN This section is available when you select ADSL/VDSL over PTM in the Type field.
Click this switch to enable or disable VLAN on this WAN interface. When the switch goes to the right
, the function is enabled. Otherwise, it’s not.
802.1p IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that
contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The greater
the number, the higher the priority level.
802.1q Type the VLAN ID number (from 0 to 4094) for traffic through this connection.
Cancel Click Cancel to exit this screen without saving.
Apply Click Apply to save your changes.
To Next Page
Loading...
