Chapter 7 Wireless
VMG/XMG Series User’s Guide
161
Figure 97 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
Table 44 Network Setting > Wireless > WPS
LABEL DESCRIPTION
General
WPS Click this switch to activate or deactivate WPS on this Zyxel Device. When the switch turns blue
, the function is enabled. Otherwise, it is not.
Add a new device with WPS Method
Method 1 Use this section to set up a WPS wireless network using Push Button Configuration (PBC). Click
this switch to make it turn blue. Click Apply to activate WPS method 1 on the Zyxel Device.
WPS Click this button to add another WPS-enabled wireless device (within wireless range of the Zyxel
Device) to your wireless network. This button may either be a physical button on the outside of
device, or a menu button similar to the WPS button on this screen.
Note: You must press the other wireless device’s WPS button within two minutes of
pressing this button.
To Next Page
Loading...
