Chapter 7 Wireless
VMG/XMG Series User’s Guide
178
8 On a computer connected to the wireless client, try to connect to the Internet. If you can connect, WPS
was successful.
If you cannot connect, check the list of associated wireless clients in the AP’s configuration utility. If you
see the wireless client in the list, WPS was successful.
The following figure shows a WPS-enabled wireless client (installed in a notebook computer) connecting
to the WPS-enabled AP via the PIN method.
Figure 107 Example WPS Process: PIN Method
7.11.8.3 How WPS Works
When two WPS-enabled devices connect, each device must assume a specific role. One device acts
as the registrar (the device that supplies network and security settings) and the other device acts as the
enrollee (the device that receives network and security settings. The registrar creates a secure EAP
(Extensible Authentication Protocol) tunnel and sends the network name (SSID) and the WPA-PSK or
WPA2-PSK pre-shared key to the enrollee. Whether WPA-PSK or WPA2-PSK is used depends on the
standards supported by the devices. If the registrar is already part of a network, it sends the existing
information. If not, it generates the SSID and WPA(2)-PSK randomly.
To Next Page
Loading...
