Chapter 9 Routing
VMG/XMG Series User’s Guide
210
Version The RIP version controls the format and the broadcasting method of the RIP packets
that the Zyxel Device sends (it recognizes both formats when receiving). RIP version 1 is
universally supported but RIP version 2 carries more information. RIP version 1 is
probably adequate for most networks, unless you have an unusual network topology.
Operation Select Passive to have the Zyxel Device update the routing table based on the RIP
packets received from neighbors but not advertise its route information to other
routers in this interface.
Select Active to have the Zyxel Device advertise its route information and also listen for
routing updates from neighboring routers.
Enable Select the check box to activate the settings.
Disable Default
Gateway
Select the check box to set the Zyxel Device to not send the route information to the
default gateway.
Cancel Click Cancel to exit this screen without saving.
Apply Click Apply to save your changes back to the Zyxel Device.
Table 66 Network Setting > Routing > RIP
LABEL DESCRIPTION
To Next Page
Loading...
