Chapter 18 Firewall
VMG/XMG Series User’s Guide
277
Figure 175 Access Control: Add/Edit
The following table describes the labels in this screen.
Table 105 Access Control: Add/Edit
LABEL DESCRIPTION
Filter Name Enter a descriptive name of up to 16 alphanumeric characters, not including spaces,
underscores, and dashes.
You must enter the filter name to add an ACL rule. This field is read-only if you are editing the
ACL rule.
Order Select the order of the ACL rule.
Select Source IP
Address
Select the source device to which the ACL rule applies. If you select Specific IP Address, enter
the source IP address in the field below.
Source IP
Address
Enter the source IP address.
Select
Destination
Device
Select the destination device to which the ACL rule applies. If you select Specific IP Address,
enter the destiniation IP address in the field below.
Destination IP
Address
Enter the destination IP address.
IP Type Select whether your IP type is IPv4 or IPv6.
To Next Page
Loading...
