ZyXEL Communications ZYWALL 5 - Security Parameters Summary; Figure 30 Zywall Wireless Security Levels; Table 23 Wireless Security Relational Matrix

ZyWALL 5 User’s Guide
102 Chapter 6 Wireless LAN
Figure 30 ZyWALL Wireless Security Levels
If you do not enable any wireless security on your ZyWALL, your network is accessible to any
wireless networking device that is within range.
Use the ZyWALL web configurator to set up your wireless LAN security settings. Refer to the
chapter on using the ZyWALL web configurator to see how to access the web configurator
6.3 Security Parameters Summary
Refer to this table to see what other security parameters you should configure for each
Authentication Method/ key management protocol type. You enter manual keys by first
selecting 64-bit WEP or 128-bit WEP from the WEP Encryption field and then typing the
keys (in ASCII or hexadecimal format) in the key text boxes. MAC address filters are not
dependent on how you configure these security features.
Table 23 Wireless Security Relational Matrix
AUTHENTICATION
METHOD/ KEY
MANAGEMENT PROTOCOL
ENCRYPTION
METHOD
ENTER
MANUAL KEY
IEEE 802.1X
Open None No Disable
Open WEP No Enable with Dynamic WEP Key
Yes Enable without Dynamic WEP Key
Yes Disable
Shared WEP No Enable with Dynamic WEP Key
Yes Enable without Dynamic WEP Key
Yes Disable
WPA WEP No Enable
WPA TKIP No Enable