ZyWALL 5 User’s Guide
646 Appendix Q Log Descriptions
Remote Management: WWW denied Attempted use of WWW service was blocked according to
remote management settings.
Remote Management: HTTPS denied Attempted use of HTTPS service was blocked according to
remote management settings.
Remote Management: SSH denied Attempted use of SSH service was blocked according to
remote management settings.
Remote Management: ICMP Ping
response denied
Attempted use of ICMP service was blocked according to
remote management settings.
Remote Management: SNMP denied Attempted use of SNMP service was blocked according to
remote management settings.
Remote Management: DNS denied Attempted use of DNS service was blocked according to
remote management settings.
Table 46 Wireless Logs
LOG MESSAGE DESCRIPTION
WLAN MAC Filter Fail The MAC filter blocked a wireless station from connecting to the
device.
WLAN MAC Filter Success The MAC filter allowed a wireless station to connect to the device.
WLAN STA Association A wireless station associated with the device.
WLAN STA Association List Full The maximum number of associated wireless clients has been
reached.
WLAN STA Association Again The SSID and time of association were updated for an wireless
station that was already associated.
Table 47 IPSec Logs
LOG MESSAGE DESCRIPTION
Discard REPLAY packet The router received and discarded a packet with an incorrect
sequence number.
Inbound packet
authentication failed
The router received a packet that has been altered. A third party may
have altered or tampered with the packet.
Receive IPSec packet,
but no corresponding
tunnel exists
The router dropped an inbound packet for which SPI could not find a
corresponding phase 2 SA.
Rule <%d> idle time out,
disconnect
The router dropped a connection that had outbound traffic and no
inbound traffic for a certain time period. You can use the "ipsec timer
chk_conn" CI command to set the time period. The default value is 2
minutes.
WAN IP changed to <IP> The router dropped all connections with the “MyIP” configured as
“0.0.0.0” when the WAN IP address changed.
Inbound packet decryption failed Please check the algorithm configuration.
Table 45 Remote Management Logs
LOG MESSAGE DESCRIPTION
To Next Page
Loading...
