ZyWALL 5 User’s Guide
344 Chapter 21 Remote Management
Figure 180 Teln e t
The following table describes the labels in this screen.
21.13 Configuring FTP
You can upload and download the ZyWALL’s firmware and configuration files using FTP,
please see the chapter on firmware and configuration file maintenance for details. To use this
feature, your computer must have an FTP client.
To change your ZyWALL’s FTP settings, click REMOTE MGMT, then the FTP tab. The
screen appears as shown.
Table 120 Teln e t
LABEL DESCRIPTION
Server Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Server Access Select the interface(s) through which a computer may access the ZyWALL using
this service.
Secure Client IP
Address
A secure client is a “trusted” computer that is allowed to communicate with the
ZyWALL using this service.
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyWALL using this service.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.
To Next Page
Loading...
