ZyWALL 5 User’s Guide
508 Chapter 39 System Maintenance Menus 8 to 10
The required fields in a command are enclosed in angle brackets <>.
The optional fields in a command are enclosed in square brackets [].
The |symbol means “or”.
For example,
sys filter netbios config <type> <on|off>
means that you must specify the type of netbios filter and whether to turn it on or off.
39.1.2 Command Usage
A list of commands can be found by typing help or ? at the command prompt. Always type
the full command. Type exit to return to the SMT main menu when finished.
Figure 325 Valid Commands
The following table describes some commands in this screen.
Copyright (c) 1994 - 2005 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys exit device ether
poe pptp aux config
ip ipsec ppp bridge
bm certificates cnm 8021x
radius
ras>
Table 193 Valid Commands
COMMAND DESCRIPTION
sys The system commands display device information and configure device settings.
exit This command returns you to the SMT main menu.
ether These commands display Ethernet information and configure Ethernet settings.
aux These commands display dial backup information and control dial backup connections.
ip These commands display IP information and configure IP settings.
ipsec These commands display IPSec information and configure IPSec settings.
bridge These commands display bridge information.
bm These commands configure bandwidth management settings and display bandwidth
management information.
certificates These commands display certificate information and configure certificate settings.
8021x These commands configure 802.1x settings and display 802.1x information.
radius These commands display RADIUS information and configure RADIUS settings.
To Next Page
Loading...
