ZyWALL 5 User’s Guide
Chapter 3 Wizard Setup 75
3.3 VPN Wizard
Use the VPN wizard screens to configure a VPN rule that use a pre-shared key. If you want to
set the rule to use a certificate, please go to the VPN screens for configuration.
Click VPN Wizard in the HOME screen to open the screen as shown and have the quick and
initial VPN configuration.
Figure 16 VPN Wizard : Gateway Setting
The following table describes the labels in this screen.
Table 12 VPN Wizard : Gateway Setting
LABEL DESCRIPTION
Gateway Policy
Property
Name Type up to 32 characters to identify this VPN gateway policy. You may use any
character, including spaces, but the ZyWALL drops trailing spaces.
My ZyWALL Enter the WAN IP address or domain name of your ZyWALL. The ZyWALL uses its
current WAN IP address (static or dynamic) in setting up the VPN tunnel if you leave
this field as 0.0.0.0. The VPN tunnel has to be rebuilt if this IP address changes.
Remote
Gateway
Address
Enter the WAN IP address or domain name of the remote IPSec router (secure
gateway) in the field below to identify the remote IPSec router by its IP address or a
domain name. Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN
IP address.
Next Click Next to continue.
To Next Page
Loading...
